Fast Cured Epoxy Anchor

Description

It is solvent-free and epoxy acrylate based 2-part fast cured anchoring adhesive. It is used for fixing of non-expanding anchors.

Usage

As a fast curing anchoring adhesive for all grades of:

Rebars / reinforcing steel
Threaded rods
Bolts and special fastening systems
Concrete
Hollow and solid masonry
Steel

Prior to any application, the suitability of the FastFix-it Adhesive for the substrate in terms of the desired bond strength, and for the prevention of surface staining or discoloration, must be confirmed by testing in a sample area. This is due to the wide variation of possible substrates, particularly in terms of strength, composition and porosity:

Hard natural stone
Solid rock

Where to Use

Example

Project-Fixing railing in Singaporean building

How to Use

1.DRILL
Drill hole to the diameter and depth required. The diameter must be in accordance with anchor size.
2.CLEAN
The drill hole must be cleaned with air blower, starting from the bottom of the hole.
The drill hole must be thoroughly cleaned with steel brush. After brush, to use air blower to clean the drill hole again.
3.INJECT
Inject the adhesive into the hole, starting from the bottom, while slowly drawing back the static mixer. In any case avoid entrapping air. For deep holes extension tubing can be used.
4.INSERT
Insert the anchor with a rotary motion into the filled drill hole. Some adhesive must come out of the hole.
5.ANCHOR
During the resin hardening time the anchor must not be moved or loaded.